IO-Warrior
The IO-Warrior is a family of USB I/O boards by Code Mercenaries, which provide a number of digital I/O pins. mAirList supports the IO-Warrior 24, 28, 28L, 40, 56 and 100.
Each pin can be used as an input, to trigger remote control commands, or as an output, controlled by a script.
Configuration
In the configuration app or Control Panel, go to Remote Control and add an interface of type IO-Warrior (USB category).
Device
On the Device tab, click Select Device… and choose your IO-Warrior from the list of connected devices. This will fill in the Vendor/Product ID, Serial Number and Path fields.
When a Path is set, mAirList will open exactly this device (i.e. the device connected to this particular USB port). Clear the Path field to identify the device by its vendor/product ID and serial number instead, so it is still found when plugged into a different USB port.
Commands
The Commands tab lists all pins of the device. The pins are named P<port>.<bit>, e.g.
P0.3 for bit 3 of port 0, followed by a consecutive number in parentheses.
For each pin, enter the command to execute when the input goes On and Off, respectively. Click a cell to edit the command.
The inputs are active-low: A pin is considered On when it is connected to ground (e.g. through a switch or relay contact), and Off otherwise.
Outputs
The pins can also be used as outputs, e.g. to drive an LED or a relay, from a background script:
IOWarriorRemote(0).SetPin(3, true);
The first parameter of IOWarriorRemote is the index of the IO-Warrior interface
(0 for the first one, if you have more than one configured).
The first parameter of SetPin is the pin number, counted from 0 (P0.0 = 0,
P1.0 = 8, etc.); the second parameter switches the output on (pulled to ground) or off.
While a pin is switched on as an output, it will not trigger any input commands.