Sonifex S0
This interface connects mAirList to a Sonifex S0 mixer via a serial port, and executes remote control commands for fader, PFL and start button events of the mixer channels.
Configuration
In the configuration app or Control Panel, go to Remote Control and add an interface of type Sonifex S0 (Sonifex category).
Select the COM Port that the mixer is connected to. The port parameters (baud rate etc.) must be set up in the Serial Ports section of the configuration first.
On the Commands tab, enter the commands for each channel (1 to 9) and event:
- Fader open / Fader close: Executed whenever the fader is opened or closed.
- PFL on / PFL off
- Start button: Executed when the start button of the channel is pressed.
- Fader+Start on / Fader+Start off: Fader start, i.e. the combination of start button and fader. The start button arms the channel (pressing it again disarms it); Fader+Start on is executed when the fader of an armed channel is opened (or when the start button is pressed while the fader is already open), and Fader+Start off when it is closed again.
For a typical fader start setup, use Fader+Start on and Fader+Start off to start and
stop the player, e.g. PLAYER 1-1 START and PLAYER 1-1 STOP.