LWRP

The Axia GPIO TCP/IP Direct Interface (LWRP) connects mAirList to an Axia console or xNode via the Livewire Routing Protocol. It uses the virtual GPIO ports of the device, so no physical GPIO wiring is required.

Configuration

In the configuration app or Control Panel, go to Remote Control and add an interface of type Axia GPIO TCP/IP Direct Interface (LWRP) (Livewire category).

On the Connection tab, enter the Host name or IP of the device. The default port is 93 (LWRP).

Players

On the Players tab, select the playlist and player, and enter the GPIO Number (port 1 to 24) that is assigned to the console channel of that player.

mAirList uses the standard Axia GPIO pin assignment for console channels:

  • Pin 4 (channel ON) starts the player.
  • Pin 5 (channel OFF) stops the player.
  • Pin 3 (PFL) switches the PFL of the player, if Automatic PFL switch is enabled.

Options:

  • Automatic PFL switch: Pin 3 switches the PFL of the player on and off.
  • Use PAUSE/STOP: When the channel is switched off, the player is paused rather than stopped.

GPO Events

The GPO Events tab lists all GPIO ports and pins. For each pin, you can enter a remote control command to execute when the pin goes High and Low.

Actions

The Set GPI action (Livewire category) sets the state of the pins of a GPIO port. For each of the five pins, select H (high), L (low), or x (no change).