Ember+ Consumer

The Ember+ Consumer remote connects to an Ember+ provider (e.g. a mixing console) via TCP/IP, and executes remote control commands when the value of a parameter changes.

Configuration

In the configuration app or Control Panel, go to Remote Control and add an interface of type Ember+ Consumer (Ember+ category).

Connection

  • Host name or IP and Port: The address of the Ember+ provider. The default port is 9000.
  • Keepalive Interval: If set, mAirList sends keepalive requests in this interval, so that a broken connection is detected and re-established.

The Monitor helps you to find the parameters you are interested in. Check Enable Monitor, then operate the device: Each parameter change is displayed in the list. Double-click a parameter to add it to the command list.

Parameter Tree

The Parameter Tree tab displays the complete parameter tree of the provider, along with the current values. Double-click a parameter to add it to the command list.

Commands

The Commands tab contains the list of parameter changes that mAirList reacts to. Each entry consists of:

  • Parameter: The path of the parameter in the Ember+ tree.
  • Value Condition and Value: A condition for the new value of the parameter: =, !=, <, <=, >=, > compare it to the specified Value, * matches any value.
  • Command: The command to execute when the parameter changes and the condition is met. The variable $VALUE is replaced by the new value of the parameter.