Remote Control

mAirList can be controlled by a wide range of external hardware and software: keyboards, MIDI controllers, USB devices, mixing consoles, network clients, and more. Each of these is set up as a remote control interface on this configuration page.

Most remote control interfaces translate incoming events (a key press, a MIDI message, a GPIO input, a fader being opened) into remote control commands, e.g. PLAYER 1-1 START. Interfaces for mixing consoles usually also work the other way round, and send the state of mAirList (e.g. “player is playing”) back to the console, e.g. to light up buttons.

This page is also available in the live configuration (mAirList Control Panel).

Managing Remote Control Interfaces

The list shows all configured remote control interfaces. The following functions are available from the toolbar:

  • Add…: Add a new remote control interface. A menu will pop up, with the available interface types grouped by category (manufacturer), and the configuration dialog of the new interface will be opened.
  • Configure: Open the configuration dialog of the selected interface. You can also double-click the entry in the list.
  • Remove: Remove the selected interface from the configuration.
  • Export: Save the selected interface(s) to an .ini file.
  • Import: Add the interface(s) from a previously exported .ini file to the list.

You can set up any number of interfaces, also more than one of the same type, e.g. when you have two MIDI controllers connected.

Players Tab

Interfaces for mixing consoles and similar devices often have a Players tab in their configuration dialog. It contains a row of tabs for each playlist, and a row of tabs for each player of the selected playlist. On these tabs, you can assign console channels, faders or GPIOs to each player (e.g. for fader start or ON AIR lamps), without having to enter raw commands. The Players tab is only displayed when at least one playlist is configured.

The interface types are described in detail on the following pages.