This is the multi-page printable view of this section. Click here to print.

Return to the regular view of this page.

Lawo/Studer

This section covers the integration with Lawo and Studer mixing consoles through the SAS protocol. For Lawo consoles with Ember+ support, see also the Ember+ section.

1 - SAS

The SAS remote connects mAirList to Lawo and Studer consoles (e.g. Lawo Zirkon, Crystal, and Studer OnAir series) through the SAS automation protocol.

mAirList identifies the console channels by their source names: When a source is selected on a fader, the console reports the source name, and mAirList knows which player is on which fader. Fader start, PFL, and GPIs of the console can then be used to control mAirList.

Configuration

In the configuration app or Control Panel, go to Remote Control and add an interface of the desired type (Lawo/Studer category):

  • SAS (TCP/IP): Connection via network. Enter the Host name or IP of the console/SAS interface, and the Port (default 18512).
  • SAS (serial port): Connection via a serial port. Select the COM Port. The port parameters (baud rate etc.) must be set up in the Serial Ports section of the configuration first.

The connection settings are found on the Communication tab.

Players

On the Players tab, select the playlist and player, and enter the Source name of the console source that the player is connected to. Leave empty to disable the assignment for that player.

When the fader of that source is opened (fader start), the player is started; when it is closed, the player is stopped.

Options:

  • Automatic PFL switch: The PFL button of the fader switches the PFL of the player on and off.
  • Use PAUSE/STOP: When the fader is closed, the player is paused rather than stopped (PAUSE/STOP command, i.e. the player is stopped if it is already paused).

Cartwall

Enter the Source name of the cartwall source. When its fader is opened, the cartwall is switched to ON AIR mode, and back to OFF AIR mode when the fader is closed. PFL on that fader switches the cartwall to PFL mode.

The options determine what mAirList does on the console when the cartwall mode changes in mAirList:

  • Open fader when cartwall goes ON
  • Turn channel on when cartwall goes ON (Studer)
  • Close fader when cartwall goes OFF
  • Turn channel off when cartwall goes OFF (Studer)

Voice Tracking

Enter the source names used for voice tracking: Player A, Player B, and Microphone. Opening the fader of the player sources starts the respective voice tracking player; opening the microphone fader starts the voice track recording. The fader levels of the player sources are applied to the volume of the voice tracking players.

Other Sources

Enter the names of further console sources (one per line) that are not bound to a player, but which you want to control with SAS actions or from scripts.

GPI

The GPI tab lists the GPIs of the console. For each GPI, you can enter the remote control command to execute when it goes On and Off.

Monitor

The Monitor tab displays the communication with the console, which is helpful for troubleshooting.

Actions

The following actions (SAS category) are available, e.g. for use in event scheduler or cartwall actions: Set fader level, Set fader input gain, Turn on/off fader start button light, Turn on/off PFL, and Turn on/off GPI.