The D&R AIRLITE is a USB broadcast mixer. mAirList does not communicate with the console directly, but through the AIRLITE Control software by D&R, using its UDP API.
The AIRLITE Control software must be installed and running on the same computer (or on the computer specified in the Advanced settings). Please refer to the D&R documentation for its installation and setup.
The D&R WEBSTATION is configured in exactly the same way.
Configuration
In the configuration app or Control Panel, go to Remote Control and add an interface of type D&R AIRLITE (D&R category).
Players
On the Players tab, select the playlist and player, and choose the USB channel used by this player, i.e. the console module that the player’s audio is connected to (or none). Opening and closing the fader of that module starts and stops the player.
Options:
- Automatic PFL switch: The CUE button of the module switches the PFL of the player on and off.
- Use PAUSE/STOP: When the fader is closed, the player is paused rather than stopped.
- Send track state: Sends the state of the player to the console, e.g. to light up the module buttons.
- Disable remote control during voice tracking: The fader does not start or stop the player while voice tracking is active.
- Disable remote control when channel is set to Line: The fader only controls the player when the module is switched to its USB input.
Cartwall
Check Use control switches for cartwall to control the cart players with the control switches of the console, and select the Buttons to use for Cartwall (“A” Buttons, “B” Buttons, or both, numbered top to bottom or left to right).
The Color Settings determine how the button LEDs indicate the state of each cart player: For each player state, select a Color (off, Red, or Green), and optionally enable Blink with a second Blink Color and a Speed.
Additionally, you can select the USB channel used by cartwall, so that the fader of that module controls the cartwall.
Modules
On the Modules tab, you can assign commands to the functions of each module (Cue, On, Fader, Start, VT), for when the function goes On and Off.
Switches
On the Switches tab, you can assign commands to the control switches (Button 1A to Button 8B) and the Non-Stop, Mic On and Silence Detection functions, for when they go On and Off.
Advanced
The Host, UDP send port (default 19551) and UDP receive port (default 19550)
for the communication with the AIRLITE Control software. The default host
(127.0.0.1) assumes that the software runs on the same computer as mAirList.
The ports should not be changed unless instructed by D&R support.