AEQ Capitol IP and Forum IP consoles can send the state of their virtual GPIOs as UDP packets over the network. This interface receives these packets and executes remote control commands when a virtual GPI changes its state.
Configuration
In the configuration app or Control Panel, go to Remote Control and add an interface of type AEQ Virtual GPIO (Capitol IP, Forum IP) (AEQ category).
On the Connection tab, enter the Bind IP (leave empty to listen on all network interfaces) and the UDP Port (default 2001). Configure the console to send its virtual GPIO messages to the IP address of the mAirList computer and this port.
On the GPI tab, enter the command to execute when a virtual GPI (0 to 255) goes ON and OFF.